Step-by-Step: Replacing the Coil on a 4V210-08
Share
Maintenance Guide: How to Replace a 4V210-08 Coil
If your Airtac 4V210-08 stops switching but the air supply is fine, you may have a burnt-out coil. Here is how to replace it without removing the valve from the manifold.
The Process
- Disconnect the power and exhaust the air system.
- Unscrew the top nut on the solenoid stem.
- Slide off the old coil and slide on the new one (ensure voltage matches).
- Tighten the nut—but do not over-torque, as it can damage the internal stem.
Replacing just the coil is a cost-effective way to extend the life of your pneumatic system.
