5 Fatal Installation Mistakes for Airtac 4V210-08

Avoid Disaster: 5 Ways to Kill a 4V210-08 During Setup

We’ve seen it all at Airtac-Shop.com. Here are the top 5 mistakes that will ruin your Airtac 4V210-08 before it even starts its first cycle.

• Mistake 1: Using too much Teflon tape. If a piece breaks off and enters the pilot hole, the valve is dead.
• Mistake 2: Reversing P and R ports. The valve won't shift and may leak internally.
• Mistake 3: Wiring AC220V to a DC24V coil. Result: Instant smoke.
• Mistake 4: Not blowing out the air lines. Construction debris in new pipes is the #1 spool killer.
• Mistake 5: Over-tightening fittings. This can crack the aluminum port threads.